-
Please checkout the new poll we will be pushing hard, and want some good stories to come out of this
result are public - you can change your vote over time, which might genuinely be the case from time to time.
Questions and electrical advice in the DIY Electrical Advice - This forum is for DIY electrical advice only. Do-It-Yourself electrical warriors are welcome in this DIY Electrics Forum. We have a few dedicated professional electricians willing to provide electrical advice to DIYers in here. Checkout THIS thread to see how you gain access to this private area of the forum..
Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrician Jobs
Search for tools and product advice,
I have a spa bath, with lights, pump and lights are straight plugged into mains with 2C+E for pump, there is an additional ground wire on metal...
I bought a new house in Florida in 2022. Today, I went into the attic. I found wiring stapled to studs in a few places, but there are no guard...
I am interested in having a home generator that would provide power to my home when the power is out during hurricane season, etc.
I have 2...
Hi,
I have a single light switch, wired like this.. the 2 wires in com, with a always live wire coming to the switch, and then wire going out to...
Hi guys. I will start by apologizing for the elementary question. I'm sure you get them often.
The chandelier is in a hallway controlled by a...
Hi there,
Any advice on this would be greatly appreciated!
(Note, this is not a DIY, I'm using a fully qualified electrician, just posting here...
I have lost the use of my two loft TV aerials due to interference from the installation of foil backed dense foam insulation. I guess this is...
Hi all,
I am planning to install wall lights such as these ones (LAP Bronx Outdoor Up & Down Wall Light Black - Screwfix -...
Can I connect the supply line and neutral to the terminals 2&4 and the load side line and neutral out of terminals 1&2
Hi, I was ironing and lost power to the bedroom and bathroom. All outlets and lights. I checked the box and reset breakers still no power. I...
I installed a transformer for 5 smart thermostats, 1 of the thermostats trips the transformer fuse button right when I turn on the power. There is...
I have cameras and 2 way devices in my home how can I locate them
Hi all,
I am about to fit a light fitting and wanted some advice whether I should just connect the light cables into the correct terminal blocks...
Hi
I've been planning to fit an outdoor junction box at the front of my house to hide a large brickwork hole and properly house the wiring...
Hi
Just want to ask is this legal for an electric car charging point? Is it safe? Its just that this is my driveway the neighbours wall, they...
Hi. I have a single phase water pump which supplies our house. It frequently cuts out and needs to be reset (on pump itself). Because of our...
Hi, Hoping someone can clarify for me. I've recently moved into a rental property, the landlord had new electric radiators installed and a new...
Can anyone help me identify which wires should go where on the little brown sliding switch?
Hi, These electric heaters have been installed and are generally operated via the HeatApp on a mobile phone. However the pairing has been lost and...
Hi
I am asking for help as a novice and 1st time user of this forum.
Recently started to experience tripping of MCB & sometimes with the RCD at...
Hi, can a 60a AC disconnect fuse box with 2 class K busman 50amp fuse work as a disconnect near the outlet ? Or would it need to be an actual...
Hi,
I've bought a "yagusmart" smart switch from Amazon and it has no earth terminal. Although there are no metal facing parts I would think the...
my wall outlet's buttons broke off and got a bit confused as all the wires are brown .what are these 2 wires for ? Thank you
Evening. Got my hands on a pair of choke ballasts to run fluorescent tubes a few days ago and I want to see if they're in good condition.
If...
In July I moved into my new home with Schluter DITRA heated floors in the bathroom. The floor quit working in December, and my GC and a rep from...
Have 2 of the wylex MCB b6 6 amp breakers that I've had blow, are these repairable ?
Hello everyone...
There are a total of 4 cables entering the junction box at the top of the staircase.
Two 12/2 cables are coming in through the...
Hello Everyone --
So, I am looking to buy a used 5HP 3PH 208 V 10 inch Table saw --- (Motor Plate Data in Image) I am a DIY'er and in...
After 24 years my septic lift station pump and high water alarm needs to be replaced. It was tripping the breaker and the alarm was no longer...
Hi,
I am restoring an old art deco, wall mount medicine cabinet. The cabinet has an 18” fluorescent light tube on each side. Before I put a lot...
I have a strip light in the kitchen operated from a single switch. I want to replace it with a straight bar 4 spot array. There are three supply...
Hello everyone, hope all are well.
I'm changing a ceiling rose and have lost the diagram showing where everything was connected (to the old light)...
Hi all. I'm going to replace some sockets during a routine redecoration of our lounge including replacing some singles with doubles with USB...
Hi all - my daughter recently bought her first house and found this electrical device in the loft. Any idea what it is? It appears to be...
Hi all,
I posted here some time ago asking for validation of a quote I received for a rewire. (10k assumed 60 points) And got some good advice so...
Hi
I currently have 4 led bulbs in the bathroom and 3 of them arent working. The bulbs that are currently in are
LOMAS LED GU10 220-240V 6000k 6w...
Hi All,
I have recently purchased a motor soft starter from aliexpress for a 3 phase motor
Before connecting load I measured the input and...
Hello, I am on Economy 7 and I have storage heaters and a hot water tank connected to a separate CU for my off-peak usage. The timer that switches...
Our home is about 40 years old and equipped with original two Federal Pacific breaker boxes. Until now we have never had any problems. A 30 AMP...
Recently moved into a house from the 70s. There's no ceiling light in the living room. Assuming the switch for the room was to one of the outlets...
Hi
I want to add a light to my attic.
There is a single switch on the landing that I want to change to a double switch and then use it to still...
Im trying to make a Star Wars Prop for a course project where the dealine is comming up very fast in days and I need to do the report so really...
Hi
we are replacing light fittings in our home. Im confident with the fitting aspect, but have run into doubt in making the right choice of...
Hi I am looking for some help.
My Rangemaster cooker hood stopped working sometime ago, I’ve stripped the hood down and degreased the hood. Ive...
Hi
My washing machine has stopped working, found this not connected inside. The wire going into was broken where it goes into this connector. Was...
We have a 5.5kW incoming supply, which cannot practicably be upgraded due to our remote location in the mountains.
Can I use a PV array and...
Hi everyone,
I need help installing a Lorex smart doorbell. I have tried to install a doorbell transformer several times to no avail.
The first...
Hi, i’ve been trying to buy a smart switch 1 gang 1 way but i opened my conventional wall switch and i only have 1 red wire(Live Old UK) 1 black...
I hope this is the right place for this. I have one phone line in my house and its a cat 6. I'm planning on adding a line in our kitchen, so my...
Hello, novice diyer here, but trying to learn more about electrical. I have done some basic wiring but that's about it. I have one of those...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
YOUR Unread Posts
-
Gold Card Fresh Meat MemberFrom reading your post electreacle I would suggest you forget about self employed for now and...- Latest: MDJ
-
Unreasonably high invoice bill from an electricianYou state your location as London. Labour rates are very high there and there's also often...
- Latest: Marvo
-
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.