-
Please checkout the new poll we will be pushing hard, and want some good stories to come out of this
result are public - you can change your vote over time, which might genuinely be the case from time to time.
Questions and electrical advice in the Electric Underfloor Heating Wiring - Electric Underfloor Heating Wiring Advice by Electricians Forums is Expert Advice from a community that started in 2006. We are the largest electric underfloor heating wiring forum. And our advice is second to non. Discounted under floor heating for all provided by uHeat.
Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrician Jobs
Forum Prefix Filter
- Sticky
All trade will get an extra discount. See information here...
Hi everone
can anyone advise me on two things
I'm having underfloor heating fitted and want to run it on my economy 7
Has anyone managed to do...
Hi all,
I've noticed that my UFH pump is not always turning on as soon as the stat & valve calls for heat. This results in hot water passing...
Hi all, taken on a new build project and they have quite a large property with three separate manifolds. I have wired before with one manifold but...
Hello Guys,
I was wondering if any of you nice chaps could lend me some advice.
So I have an open vented heating system with a 3 port valve...
I have electric underfloor heating. The thermostat lights on but there's no heat felt via the floor.
The termostat is a Time Guard UFPT7.
What...
Hi.
I'm installing a wet underfloor heating system in my own house. What would you recommend as the best smart control system? I can hardwire...
What’s the best setup for a system that has a heating system with existing radiators but a wet underfloor heating system is being added to a new...
Calculate the temperature rise in a system consisting of six conductors carrying 1500 amperes each at 132kV, insulated with XLPE, and spanning a...
m having a bit of an issue that is proving difficult to resolve.
For 2 years I have been having no problems with my setup. I have a 3 zone house...
Hello All, I have Adept TW02W wifi Thermostat - does anyone know how to reset it?
I have a loose wire underfloor heating system I am installing for a client ideally they would like the UFH to continue into the down stairs loo...
I have a customer that has 3 heating mats under the tile. This was installed a while back and a relay was used. I measured a 21 amp draw for all...
Hi guys/gals,
Had a message from an old customer from my old firm whos having problems with their stat.
They have 3 electric ufh using the same...
Hi,
I'm getting renovations done to my home, including an existing extension which already has wet underfloor heating. We are moving a kitchen...
Hi,
I'm looking for some help with an UFH thermostat that I can't find the model of. All I can see is that it's made by Rehau. Installed roughly...
Hi. I have very old underfloor heating with thermostats. I'd like to replace the thermostats with timer/thermostats if possible. The current...
I recently wired a heating system with a UFH8 manifold and an unvented cylinder.... easy.
Well it threw up a few problems.
Initially I had the...
Hi. I’ve recently had installed a manifold (including zone valve and pump) for the newly installed Wet UFH in my extension.
The system is split...
Morning all,
I'm about to embark on some home renovation and the kitchen is the first target. We are looking at making it bigger, all in the room...
I've had a electrician say i need to come from fcu but its going on a dedicated rcbo do i need fcu
Hello,
The floor boarding has been stuck down with adhesive and screwed down also with extra metal washers.
Someone has now told me it is not a...
Hoping someone knows of a product that can be used for a single UFH zone with 3 heads and two radiators zones. The heat miser UH4 can use zone4...
We are replacing the flooring for the whole ground floor - it is a circa-2000-build house with concrete slab.
We're taking the opportunity to put...
What are your thoughts on using electric underfloor heating as a primary heat source in a church?
It's a typical old church building - a couple...
All of the UFH thermostats that I have ever fitted have had the air temperature sensor integrated into the hard-wired wall mounted programmer...
Hi I have a heatmiser uh4 wiring centre and a grant vortex combi condensing oil boiler, doing the heat and HW in a small cottage, the room stats...
Hi, I would like some advice on using Tado with electric underfloor heating to ensure it is
I have Tado contolling my boiler and radiators...
Hi all, Am planning controls of some existing underfloor electric mats that have previously had inadequate controls fitted. So far have tested and...
Hello, could any one recommend a Rf thermostat . It’s for elderly customer so reliable and simple are main requirements.
Thanks
Long story short, I forgot to mark where my cables were prior to installing laminate. I accidently skimmed the side of a cable for one of the...
Evening all,
Doing a bit of forward planning for an extension with possible electric ufh. i Have worked out room will need 25m2 split between 2...
I'm a total amateur so apologies in advance for any stupid question. I have a white box with a tiny timer button which you can turn from 1 minute...
I am a DIYr.
I have a gas fired underfloor heating system installed about 12 years ago. The controllers are Uponor C35 and thermostats T35...
I have two hive zones. One for the house and one for the UFH in the kitchen.
When I boost the UFH from the thermostat or the Hive app the light...
Hi guys just in the process of wiring up a 3 zone Drayton jb with 3 zone wireless heating controls.
My question is as it stands at the moment...
Evening,
im going to try and explain the heating system im currently wiring, I have most of it wired up, there’s just a few bits im not sure of...
Hi. We have moved into a new build house in Feb this year that has infrared underfloor heating and an economy 7 tariff. For info we also have...
Hi guys!
I bought a pool heater online and this Is the wiring diagram that comes with It. Can someone please tell me if this Is possible? From...
At a rewire today, client has decided he wants underfloor heating all through his house. This is what will be heating his house. Downstairs it’s 4...
Ringmain fed by 32A mcb on split board protected by rcd,I'm spurring of ring feeding a underfloor heating system rated at 9A ,I know I can fit a...
Whist looking up something unrelated in section 701, I noticed reg 701.753
Stating that underfloor heating wire in a bathroom must have an...
hi ALL,
I wired an electric UFH mat in a lounge, mat company said I can use this size mat for one programmer, it was at its max, I wired it...
Hi guys
Looking for some advice with regard to wiring a heating system. Starting a new build next week and have little if any experience with...
Hello! I have a wall heater, connected to 2 switches. One of them is offpeak, only works from 12 to 07 AM. I would like to change that switch or...
Ea
Hi Guys
Just after some advice if possible. I have wired an extension and the plumber has fitted a manifold for the new UFH which he has asked me...
Hi all, i'm a home owner just looking for some advice.
Over Christmas the RCD on a split panel fuse box kept tripping. We narrowed this down to...
I'm getting started on rehabbing my house and I want to install an electric underfloor heating system that I can eventually control through an...
Warmup UFH laid about 10 years ago, working fine but supply unit humming terribly and was replaced a few weeks ago. Since then only a third of the...
A friend is asking for help to sort out a dispute between her Builder and Electrician each blaming the other for electric under floor heating...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
YOUR Unread Posts
-
External Consumer UnitThere are also stainless steel options in that range and not too expensive (comparatively).- Latest: nicebutdim
-
Best certification softwarehttp://www.tysoft.co.uk/easycert.htm I have used this software for years and find it excellent...- Latest: SparkySy
-
Dodgy trade pictures for your amusement! - 1 Million Views!Looks a bit flip floppy to me.... are they cooking sole(s) on a griddle?- Latest: ipf
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.